Products

35D-9 / 40D-9 / 45D-9 / 50DA-9 DIESEL COUNTERBALANCE TRUCKS TECHNICAL SPECIFICATIONS Units Measurements Load capacity 3,500 / 4,000 / 4,500 / 5,000 kg Engine model Cummins QSF3.8 Engine power 102 ps @ 2,200 rmp Battery voltage N/A Lifting speed loaded 510 / 500 /490 / 420 mm/s Lifting speed unloaded 540 / 540 / 540 / 460 mm/s Travel speed loaded - Travel speed unloaded 26.6 / 25.6 / 25.6 /25.6 km/h Turning radius 2,950 / 2,950 / 2,990 / 3,008 mm

Features: Easy installation Corrosion free Jerk free functionality Longer life High performance Low maintenance

We are a most popular name in the market offering an extensive array of Forklift Engine Cylinder Liner. Features: Corrosion resistance Easy installation Piston ring attached Light weighted Precise dimension High strength

Novel Industrial Equipment and Services can also provide spare parts following: Forklift Spare Parts for all makes and models ( e.g. Toyota Forklifts , Komatsu Forklifts, Nissan Forklifts, Hyundai Forklifts) Forklift Tyres & Rims Forklift Batteries & Chargers Forklift Attachments Side Shift Tyne/Fork Slippers Carton Clamp 180/360 degree rotators Fork Positioner Side Shifting Fork Positioner Push Pull Carpet Pole Bale Clamp Wide carriage Safety Cages Container Handlers

Model 70DF-7 Load Capacity (Kg) 7000 Load Center (mm) 600 Engine Make HMC D4DD Flywheel Power(gross) 100.1 @ 2300 Minimum Turning Radius (mm) 3442 Gradient (%) 38.5 Tyres Solid/ Pneumatic / Non Marking Transmission Automatic

Brake drums are made from rolled bar or cast steel. The brake drums are fully machined to eliminate vibration. Brake drums are dynamically balanced after machining when required by customer. The drum surface is treated to achieve high hardness for longer life.

Wheels are supported in L type bearing blocks. Wheels are made from forged steel/ cast steel and machined accurately. Wheels are suitably heat treated to achieve hardness of 250 – 300 BHN with volume hardening or 450 – 500 BHN with Induction hardening as per customer requirement. Tram wheels with either non ferrous bush bearing or antifriction bearing and open gear attached are also supplied as required by customer

Steel Wire Ropes with IWRC (Steel Core) as well as Fibre Core. Special features such as anti rotation, galvanized and Stainless steel ropes are also available

Sheave made from Cast Steel with grooves machined accurately for wire rope support. Sheaves with hardened groove are also available

Rope Band & Guide are made from Cast Iron. Rope band and guide can also be supplied based on your sample

Pendent Cable with built in steel wire is available ex stock.

Two, Three and Four Stage gearboxes are supplied from Crane Hoisting application. The gearbox casing is made from MS fabricated plates. The casing is thermally stress relieved after welding. The casing is accurately machined on horizontal boring machine. The helical gears and pinions are made from rolled/ forged steel of En9/ En19/ Cast Steel material as per design requirement. Gears and pinions are oil quenched and tempered to achieve toughness as well as surface harness. Gear teen are machined hob cut. Case hardened gear teeth are supplied as required. Shafts are supported on antifriction ball and roller bearings. Oil seal seat on shaft are have ground finish. Gears and pinions are Splash lubricated.